Dmx Connection; Set Up; Control Panel - Evolite Xpress Beam 7x12 User Manual

o DMX 512 Connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or
properly. Please note the starting address depends upon which controller is being used. Only use a
DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or
one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried
out in compliance with IEC standards.
 Set up

Control panel

o
The control board offer several features: you can simple set the starting address, run the pre-
programmed program or make a reset
The main menu is accessed by pressing the Menu button, Browse through the submenu by pressing
Up or Down .Press the Enter-button in order to select the desired menu. You can change the
selection by pressing Up or Down, Confirm every selection by pressing the Enter-button. The
functions provided are described in the following setting.
Xpress Beam 7x12 Manual Ver. 1.00 Page 15