Setup: - Evolite HYBRID 17R User Manual

Lamp: turn on / off the lamp. After changing the value, it takes about 3 seconds to work. You can switch the
value back in 3 seconds and cancel the operation. After turning off the lamp, it has to wait for 1~2 minutes before
it can be on again. If turn on the lamp in two minutes, the lamp will be on till the 2 minutes later.
If this menu item is "on", the system will try to light the lamp firstly and wait for the light board to return.
Manual control: manually setting the value of the channel
Pan: sets the DMX value of the Pan
......
Automatic return: if there is no action for more than a certain time, the manual control menu is
automatically withdrawn. The time for waiting to exit is set by this menu.
Run settings: running parameter settings.
Tilt settings:
Reverse: reversing the rotation direction of the Tilt motor
Starting point: setting the starting point of the Tilt motor (the value of the console corresponds to 0,
adjusting this value to watch the rotation angle in real time)
End point: setting the terminal position of the Tilt motor (the value of the console corresponds to 255,
adjusting this value to observe the rotation angle in real time)
Pan settings:
Reverse: reversing the rotation direction of the Pan motor
Starting point: setting the starting point of the Pan motor (the value of the console corresponds to 0,
adjusting this value to watch the rotation angle in real time)
End point: setting the terminal position of the Pan motor (the value of the console corresponds to 255,
adjusting this value to observe the rotation angle in real time)
Master/slave mode: set slave mode when receiving the external DMX signal; set master mode when sending
the DMX signal as host.
Music control setup: sound control mode setting
Sound control mode: select the effect of performing sound control.
The menu options are described as follows:
Dimming: brightness changes following the music volume
Color: the color will change automatically with music
Pattern: the fixed Gobo wheel changes the pattern automatically with the music
Other channels: except the sound control mode, other channel control mode as below:
The menu options are described as follows:
DMX: DMX console control operation. Please note in this mode, if the sound control mode is dimming,
the shutter must be opened by the console operation. If the sound control mode is color or pattern and other
modes, the shutter must be opened and the brightness is adjusted.
Automatic: running the program set by the manufacturer
Manual: set the value of the channel through the menu [manual control]. This pattern is similar to DMX,
and needs to be handmade to set the shutter or brightness.
Sensitivity: setting the sensitivity of sound control
Mixed scenario: user programming scene playback settings. More instructions on user programming
Number of playgrounds: set the number of scenes to be played
Scene editor: edit the scene. More instructions on user programming
Scene number: select the number of scenes to be edited
Step number: in the selected scene, select the number of steps to be edited
Step edit: click into the edit
Time: the duration of the selected step (unit is 0.1 second, for example, a value of 123, representing 12.3
seconds)
Channel: select the channel that you need to edit in this step
Value: edit channel value
Copy: copy selected scene sequence number and step number
Paste: paste the copied scene sequence number and step number into the selected scenes and steps.
(remember, this operation directly covers the original value. Please paste the target scene
and steps before sticking.
Hybrid 17R Manual Ver. 1.00 Page 21