commtech wireless 7900 Programming Manual page 9

Manual
11. Then place the pager facing upwards into the programming cradle as shown
below.
12. Just prior to reading or writing you will need to press down hard so that there is
a good contact between the pager and programmer pins.
13. Before reading or writing, you can always tell if the pager is making good contact
with the programming jig by looking at the Status Bar. As seen below, it will
show NO PAGER if it detects no pager, or if the pager is not properly inserted.
14. Once a good contact is made, it will show Pager Inserted.
CommtechWireless
©
7900 Pager Programming
Page
9