commtech wireless 7950 Quick Manual

THE 7950 PAGER

Case Layout

1.1

Hand Programming Menu

1.2
 With the pager turned on, hold down the
 You will be prompted for a four digit numeric password.
 Use the
selected digit. Press the
are entered, press the
0200.
 Once you are in the programming menu, you will see the first four cap codes ready for viewing or
editing. There are eight cap codes available in total. The A, B, C, D, E, F, G, H at the start of the line
corresponds to cap code 1 to 8.

NOTE: If you just need to change frequency or baud rate and not any capcodes, you can press the
Arrow Key to jump to that screen.
 Each cap code can be enabled or disabled if required. This is what the ON or OFF field before each
cap code refer to.
 Use the
Key to move to the next field.
Escape Key to increase the selected digit and the
Arrow Key to move along to the next digit. After the correct digits
Arrow Key to proceed to the first screen. By default this password is
Escape Key and
Escape Key and
PASSWORD:0000
A: [ ON] 0000008
B: [ ON] 0000016
C: [ ON] 0000024
D: [ ON] 0000032
Read Key to change the selected field. Use the
Read Key for 3 seconds.
Read Key to decrease the
Arrow