Standalone Positioning - Huawei ME936 Application Manual

HUAWEI ME936 LTE M.2 Module
Application Guide

14.2 Standalone Positioning

Command
AT^WPDOM=0
OK
AT^WPDST=0
OK
AT^WPDST=1
OK
AT^WPDFR=0,1
OK
AT^WPDFR=10,2
OK
AT^WPQOS=255,50
OK
AT^WPDGP
OK
Issue 02 (2017-12-11)
Open GPS Interface, then the positioning starts. So if you want to start the positioning by AT
command in PC UI Interface, you need execute AT^WPDGP command in PC UI Interface
before opening GPS Interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GPS Application Scenarios
Description
Sets the positioning method to
Standalone.
Sets the session type to single
positioning.
Sets the session type to tracking
positioning.
Sets unlimited positioning times and
the interval between each positioning
for the tracking and positioning. If the
session is a single positioning, you do
not need to set these parameters.
Sets the number of positioning times
and the interval between each
positioning for the tracking and
positioning. If the session is a single
positioning, you do not need to set
these parameters.
Sets the positioning service quality.
The first parameter indicates the
response time, and the second
indicates the horizontal accuracy
threshold. This command is just valid
for single positioning.
Starts positioning.
72