Troubleshooting - Tunturi FitRun 70i User Manual

Hide thumbs Also See for FitRun 70i:
Table of Contents

Advertisement

Available languages

Available languages

The treadmill is designed to keep the running belt
reasonably centered while in use. It is normal for some
belts to drift near one side while the belt is running with
no one on it. After a few minutes of use, the running
belt should have a tendency to center itself. If, during
use, the belt continues to move toward one side,
adjustments are necessary.
Exception: During rehabilitation where the user is using
one leg much stronger than the other, it might happen
that the running belt drifts to one side. In these cases
you should not adjust unless the running belt does not
centre itself during normal condition usage.
To set running belt tracking (fig. F-5)
A 10 mm Allen wrench is provided to adjust the rear
roller. Make tracking adjustments from the left side only.
Set belt speed at approximately 3 to 5 kph.
Remember, a small adjustment can make a dramatic
difference!
Turn the bolt clockwise to move the belt to the right.
Counterclockwise to move to the left. Turn the bolt only
a 1/4 turn and wait a few minutes for the belt to adjust
itself. Continue to make 1/4 rotation turns until the belt
stabilizes in the center of the running deck.
The belt may require periodic tracking adjustment
depending on use and walking/running characteristics.
Some users will affect tracking differently. Expect to
make adjustments as required to center the tread-belt.
Adjustments will become less of a maintenance concern
as the belt is used. Proper belt tracking is an owner
responsibility common with all treadmills.
NOTE
Damage to the running belt because of incorrect
running-belt adjustments is not covered by the
products warranty.

Troubleshooting

Despite continuous quality control, defects and
malfunctions caused by individual components may
occur in the equipment. In most cases it's unnecessary
to take the whole device in for repair, as it's usually
sufficient to replace the defective part.
If the equipment does not function properly during use,
contact your Tunturi dealer immediately. Always give
the model and serial number of your equipment. Please
state also the nature of the problem, conditions of use
and purchase date.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number
for the part you need. The spare part list is at the back
of this manual. Use only spare parts mentioned in the
spare part list.
Error codes
If the display shows an error code
(marked with "E"/ "DC" + number), restart the
equipment and check whether the display still shows
the error code. If the display still shows the error code,
immediately contact the dealer.
Transport and storage
WARNING
Before cleaning and maintenance, remove the
mains plug from the wall socket.
Carry and move the equipment with at least two
persons.
Make sure that there are no other persons or
objects under the equipment.
When folding the folding the equipment,
make sure that you hear the equipment lock
into position to prevent the equipment from
dropping back down.
CAUTION
Before folding the equipment, make sure that
the incline is 0%. If the incline is not 0%, folding
will damage the mechanism.
-
Move the equipment as shown (fig. F3). Move
the equipment and carefully put the equipment
down. Place the equipment on a protective base
to prevent damage to the floor surface. Move the
equipment carefully over uneven surfaces. Do not
move the equipment upstairs using the wheels, but
carry the equipment by the handlebars.
-
Store the equipment in the upright position (fig.
F1). Store the equipment in a dry place with as little
temperature variation as possible.
Additional information
Packaging disposal
Government guidelines ask that we reduce the amount
of waste material disposed of in land fill sites. We
therefore ask that you dispose of all packaging waste
responsibly at public recycling centres.
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable
use from your fitness trainer. However, a time will come
when your fitness trainer will come to the end of its
useful life. Under 'European WEEE Legislation you are
responsible for the appropriate disposal of your fitness
trainer to a recognised public collection facility.
2 9
English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fitrun 90i pro

Table of Contents