Troubleshooting - Tunturi pure run 10.1 User Manual

slip. Keep tensioning the bolts until the
belt stops slipping.
If you feel the belt is tight enough, but it
still slips, the problem may be a loose
Motor drive belt under the front cover.
Do Not Overtighten
Over tightening will cause belt damage
and premature bearing failure.
running belt tracking adjustment:
The performance of your treadmill is
dependent on the frame running on a
reasonably level surface. If the frame is
not level, the front and back roller cannot
run parallel, and constant belt
adjustment may be necessary.
The treadmill is designed to keep the
running belt reasonably centred while in
use. It is normal for some belts to drift
near one side while the belt is running
with no one on it. After a few minutes of
use, the running belt should have a
tendency to center itself. If, during use,
the belt continues to move toward one
side, adjustments are necessary.
exception:
During rehabilitation where the user is
using one leg much stronger than the
other, it might happen that the running
belt drifts to one side. In these cases you
should not adjust unless the running belt
does not centre itself during normal
condition usage.
To set running belt tracking:
A 10 mm Allen wrench is provided to
adjust the rear roller. Make tracking
adjustments from the left side only. Set
belt speed at approximately 3 to 5 kph.
Remember, a small adjustment can
make a dramatic difference!
O w n e r ' s m a n u a l
Turn the bolt clockwise to move the belt
to the right. Counterclockwise to move to
the left.Turn the bolt only a 1/4 turn and
wait a few minutes for the belt to adjust
itself. Continue to make 1/4 rotation
turns until the belt stabilizes in the center
of the running deck.
The belt may require periodic tracking
adjustment depending on use and
walking/running characteristics. Some
users will affect tracking differently.
Expect to make adjustments as required
to center the tread-belt. Adjustments will
become less of a maintenance concern
as the belt is used. Proper belt tracking
is an owner responsibility common with
all treadmills.
NOTe:
Damage to the running belt resulting
from improper tracking /tension
adjustments is not covered under the
warranty.

Troubleshooting

Despite continuous quality control,
defects and malfunctions caused by
individual components may occur in the
equipment. In most cases it's
unnecessary to take the whole device in
for repair, as it's usually sufficient to
replace the defective part.
If the equipment does not function
properly during use, or shows an error
code, stop your workout immediately.
Unplug the power cord and wait a few
minutes. Plug the power cord in and
check if the problem persists.
Mostly this will reset your treadmill and
eliminates error code.
If the problem still persists contact your
Tunturi dealer immediately. Always give
the model and serial number of your
equipment. Please state also the nature
of the problem, conditions of use and
purchase date.
If you require spare parts, always give
the model, serial number of your
GB
•
P u r e r u N 1 0 . 1
29