Notes; Safety Instructions - BMW I Wallbox Installation Instructions Manual

NOTES

Safety instructions

Read the safety instructions carefully and examine the device, so that you become familiar with it,
before you attempt to install operate or maintain it.
WARNING
Electrical danger!
Installation, commissioning, maintenance and retrofitting of the Wallbox must be carried out
by appropriately trained, qualified, and authorized electricians
for complying with the applicable standards and installation regulations.
Please note that additional overvoltage protector may be required by vehicles or national
regulations.
Comply with the country-specific connection and installation regulations.
Before commissioning, confirm that all screwed and clamped connections are tight!
The connector panel must never remain unattended while it is open. Fit the connector
panel cover if you leave the Wallbox unattended.
Do not undertake any unauthorized conversions or modifications of the Wallbox!
Repair work on the Wallbox is not permitted, and may be carried out only by the
manufacturer or by a specialist qualified for the task (replacement of the Wallbox)!
Do not remove any markings such as safety symbols, warnings, performance rating plates,
identification plates, or cable markings!
The Wallbox does not have a power switch of its own! If present, the connector plug serves
as a power cut-off device. Otherwise, the line protection in the building installation serves
as a power cut-off device.
Use only the plug (and not the cable itself) to pull the charger cable out of the plug holder.
Ensure that the charger cable does not become mechanically damaged (kinked, trapped, or
driven over) and that the contact area does not come into contact with heat sources, dirt or
water.
Do not insert your fingers into the plug connector.
A visual inspection for damage should always be conducted before a charging process.
For this, the contact area of the charging plug in particular should be checked for dirt and
moisture, the charger cable checked for cuts or abrasions to the insulation, and the cable
outlet of the Wallbox checked for firm seat.
Persons who, on the basis of their specialist training, knowledge, and experience, as well as
(1)
knowledge of the applicable standards, can assess the tasks assigned to them and recognize possible
dangers.
, who bear full responsibility
(1)
9