Operation - Proxxon MICROMOT 50 Manual

Accessories:
Drill chuck for Micromot machines
Power unit NG 2 (S/E) or NG 5 (E)
Drill stand MBS 140
Universal holder UH 34

Operation

Clamping, changing tools
Attention!
Disconnect mains plug before changing tools.
Never press the locking knob (arrow Fig. 2)
while the machine is running.
1. Turn the spigot nut 1 (Fig. 2) gently while
pressing the locking knob until it engages.
2. Open the clamping jaw and change the
tool.
Clamp all tools as short as possible. Shafts,
which protrude too far will bend easily causing
the machine to vibrate.
Power supply
Use only power units with a minimum power
output of 1 A. We recommend use of the
PROXXON power units NG 2 (S/E) or NG 5 (E).
1. Push the non-reversible plug into the power
unit.
If overloaded, the PROXXON power unit will
switch off automatically. Disconnect mains
plug and let the power unit cool down for a
few minutes.
Working with the machine
Always wear goggles.
Do not use any broken grinding discs or bent
shafts.
2. Switch the machine on 1 or 4 (Fig. 1) and
set the correct speed (50/E only) with the
button 1.
Pressing hard does not achieve good results
when grinding. Use the correct speed and
maintain it.
Small tools pins = high speed
Big tools pins = low speed
3. Fig. 3 shows two typical methods for
holding MICROMOT 50. When working,
ensure that the tool is held firmly in order
to guide the rotating application tool in a
controlled manner without thereby blocking
the ventillation slots.
4. If the unit overheats, switch it off and
allow it to cool for a few minutes.
The electronic speed regulation works only
with non-stabilized power units (e. g. all
PROXXON power units). If connected to a
battery, the unit will only run at max. speed.
EC declaration of conformity
We declare sole liability for conformity of this
product with the following EC guidelines:
• EC-EMC Guideline 89/336
DIN EN 55014-1/09.2002
DIN EN 55014-2/08.2002
DIN EN 61000-3-2/12.2001
DIN EN 61000-3-3/05.2002
• EC-Machine Guideline 98/037
DIN EN 60745-1/12.2003
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Department for Equipment Safety
Note:
- 7 -