Proxxon MICROMOT 50/E Manual
  1. Manuals
  2. Brands
  3. Proxxon Manuals
  4. Power Tool
  5. MICROMOT 50/E
  6. Manual

Proxxon MICROMOT 50/E Manual

Hide thumbs Also See for MICROMOT 50/E:
Table of Contents

Advertisement

Quick Links

Download this manual
MICROMOT 50/E
Manual

Advertisement

Table of Contents
loading

Related Manuals for Proxxon MICROMOT 50/E

Summary of Contents for Proxxon MICROMOT 50/E

  • Page 1 MICROMOT 50/E Manual...
  • Page 2 Fig. 1 Fig. 2 Fig. 3 - 3 -...
  • Page 3 PrOXXOn - Micromot 50/e properly fit the spindle or collet of the power tool. Accessories that do not match translation of the Original the mounting hardware of the power tool Operating instructions will run out of balance, vibrate excessively and may cause loss of control.

  • Page 4: Further Safety Instructions For All Op- Erations

    k) Hold power tool by insulated gripping tion of powdered metal may cause electrical surfaces only, when performing an oper- hazards. ation where the cutting accessory may contact hidden wiring or its own cord. s) Do not operate the power tool near flam- Cutting accessory contacting a “live”...
  • Page 5 the rotating accessory and cause loss of the wheel in the cut and the possibility of control or kickback. kickback or wheel breakage. c) Do not attach a toothed saw blade. Such d) Do not position your hand in line with blades create frequent kickback and loss of and behind the rotating wheel.

  • Page 6: Scope Of Delivery

    1 pc. Operating instructions Description of machine 1 pc. Safety guidelines The PROXXON drilling and milling machine MI- 6 pcs. Collets (1.0-1.5-2.0-2.4-3.0 and 3.2 CROMOT 50/E is the ideal tool for precise drilling, milling, grinding, polishing, brushing, 1 pc. Round grinding pin Ø 5mm rust removal, engraving, chasing and cutting.

  • Page 7: Technical Data

    The arbour of the tool The electronic speed regulation works only with must be seated firmly and securely in the col- non-stabilized power units (e. g. all PROXXON let! power units). If connected to a battery, the unit •...

  • Page 8: Ec Declaration Of Conformity

    Every device is dirtied by dust when working. Product designation: Cleaning is therefore essential. To ensure a Drilling and Milling Set with Micromot 50/E long service life, however, the machine should Article No.: 28515 be cleaned with a soft cloth or brush after each In sole responsibility, we declare that this use.
  • Page 9 et - nr.: Description 28500 - 50 Swivel nut for collet chucks (accessories) 28500 - 51 Collet chuck (accessory) 28500 - 53 Locking ring 28500 - 54 Ball bearing 28500 - 56 Shaft lock 28500 - 60 Housing screw 28500 - 61 Threaded rod 28500 - 62 28500 - 63...
  • Page 10 Service note All PROXXON products are thoroughly inspected after production. Should a defect occur nevertheless, please contact the dealer from whom you purchased the product. Only the dealer is responsible for handling all legal warranty claims which refer exclusively to material and manufacturer error.

Table of Contents