Proxxon MICROMOT 50 Manual page 2

PROXXON - MICROMOT 50 (E)
GB
Dear customer,
Please read the enclosed safety regulations
and operating instructions carefully before
using the unit.
Safety regulations
Attention!
Please read and apply the following safety
regulations carefully before using the machine,
thereby protecting yourself and others.
- Keep the working area clean and tidy.
- Do not use electrical tools in rain, under wet
conditions or in the vicinity of inflammable
liquids or gases.
- Avoid contact with earthed parts such as
pipes, radiators cookers and refrigerators.
- Keep children away from the working area.
- Always wear goggles.
- Wear a breathing mask under dusty working
conditions.
- Store unused tools in a locked room out of
the reach of children.
- Do not overload the machine.
- Do not use weak tools for heavy duty work.
- Do not carry the machine by the power
cable.
- Protect the power cable against heat and
sharp edges and only have it replaced by a
specialist.
- Fasten and clamp the work piece securely.
- Replace blunt tools.
- Clean the machine thoroughly after use.
- Always disconnect the power cable if the
machine is not in use, when changing tools
or case of repairs.
- Inspect unit for damage before use.
- Replace defective parts.
- Repairs in the electric system should be
carried out by a specialist.
- Use only accessories and spare parts which
are recommended in these instructions or by
the manufacturer.
- 6 -
Drilling and milling machine
Overview
Legend
1. ON - OFF switch with speed control
(MM 50/E only)
2. Hook
3. Power cable
4. ON - OFF switch (MM 50 only)
5. Locking pin
6. Spigot nut with steel clamping jaw
7. 20 mm fitting for mounting in drill stand
Description of machine
The PROXXON drilling and milling machine
MICROMOT 50 (E) is the ideal tool for precise
drilling, milling, grinding, polishing, brushing,
rust removal, engraving, chasing and cutting.
For hobby electronics, model making,
precision mechanics, jewellery shops,
opticians, arts, tool and mould making.
For marking tools and cameras.
It can be used on steel, non-ferrous metals,
glass, wood, minerals and ceramics.
The drill spindle is supported in a precision
ball bearing which eliminates any play.
Excellent handling because of the
pen-type grip.
The machine is reliably driven by a high torque
motor. Type 50/E is fitted with an electronic
speed regulator.
Technical data
Length:
Weight:
Spindle collar:
Motor:
Speed (50):
Speed (50/E):
Voltage:
Power consumption:
Noise level:
Please do not dispose
off the machine!
approx. 220 mm
approx. 230 g
ø 20 mm
20 000 rpm
5000 to 20 000 rpm
12 to 18 V
approx. 40 W
≤ 70 dB (A)