Fingerprint Sensor - HP 340 G7 Maintenance And Service Manual

Fingerprint sensor

Table 5-9 Fingerprint sensor description and part number
Description
Fingerprint sensor, pike silver
Fingerprint sensor, stone silver
Fingerprint sensor bracket
Fingerprint sensor cable
Before removing the fingerprint sensor, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
To remove the fingerprint sensor:
1. Disconnect the cable (1) from the ZIF connector on the system board, and the lift the cable to release it
from the computer (2).
2. Remove the two Phillips M2.0 × 2.0 screws (3) that secure the sensor bracket to the computer, and then
remove the bracket (4).
3. From the bottom, push up on the fingerprint sensor (5) to remove it.
Reverse this procedure to install the fingerprint sensor.
(Preparation for disassembly on page
Computer feet on page
Bottom cover on page
Battery on page 31).
27).
29).
Component replacement procedures
Spare part number
L81413-001
L81414-001
L84322-001
L81412-001
27).
39