Machine Preparation - Walinga Grain-Vac 7614F Operator's Manual

4.9 Machine Preparation

Before the Grain-Vac can be used it must be
set up and prepared for operation.
When setting-up, follow this procedure:
1. Clear the area of bystanders,
especially small children.
2. Be sure you select a spot that has
sufficient space to locate the machine
and enough clearance to allow trucks
to drive under the discharge cyclone.
3. Position the machine approximately 8
feet from the storage facility. The PTO
shaft should be straight, by having the
tractor and machine in a straight line.
4. Engage hydraulic lever to operate the
hydraulic circuit.
5. Place all other controls in neutral and
set park brake on the tractor before
dismounting.
6. Remove the plug from the receiver
tank inlet.
7. Remove the intake nozzle from its
storage position on the frame and
install on the end of the steel flex tube.
Secure in position using the wing bolts
on the coupler.
8. Connect the 8 foot steel flex tube to
the inlet. Tighten the wing bolts on the
coupler to lock the tube securely in
place.
Try to have the hose as
straight as possible.
7614F Grain-Vac Operator's Manual 34-100853-6
Fig. 4-8 Bin Clearance 8 ft
Fig. 4-9 Flex Tube Installation.
27