Walinga Grain-Vac 7614F Operator's Manual page 37

4.10 OPERATION (cont'd)
9.
b. Storage:
To prepare the machine for storage,
remove the inlet pipe and spray the
blower clean with water, then run at idle
for 5 minutes to dry the inside of the
tank, piping, blower and airlock. This
will prevent any residue from caking on
the internal components.
10. Use the regular nozzle until there is
approximately 12 inches of the grain left
in the bin. Then switch to the clean-up
nozzle to pick up the last of the grain.
11. When using the clean-up nozzle, it is
recommended that the rubber intake
hose be installed to allow you to move
around to pick up the grain from the
corners more easily.
12. Stopping Machine:
a. Remove the intake nozzle from the
grain.
b. Allow the unit to run until the grain
has stopped coming out the cyclone.
c. Stop the airlock.
d. Slow the engine speed down to a low
idle for 5 minutes.
e. Disengage the hydraulic circuit and
slowly disengage the PTO clutch.
f. Stop the engine.
7614F Grain-Vac Operator's Manual 34-100853-6
Fig. 4-20 Using The Clean-Up Nozzle In the Bin.
Fig. 4-21 Nozzle and Hose Storage
34