Blower Oil Changing And Breather Cleaning - Walinga Grain-Vac 7614F Operator's Manual

5.2.2 BLOWER OIL CHANGING AND BREATHER CLEANING

4. Changing Oil:
a. Place a collection pan or pail under
each drain plug.
b. Remove each drain plug.
c. Flush each case and allow several
minutes to drain.
d. Dispose of the oil in an approved
manner. Do not contaminate the
worksite with used oil.
e. Install and tighten the drain plugs.
f. Remove the fill and level plugs.
g. Add Walinga Blower oil or equivalent
to each reservoir until the oil is just
starting to come out of the level plug
hole.
Condensation forms and collects inside
the reservoirs during machine
operation. Changing oil removes this
water and prevents it from damaging
the gears and bearings.
h. Install and tighten the level and fill
plugs.
5. Cleaning Breathers:
a. Remove the breathers, and blow the
breathers out with an air hose.
b. If dirt has caked up in the breather,
soak the breather in good solvent and
then blow out.
It may be necessary to use a probe to
loosen the dirt.
c. Install and tighten the breather.
d. Clean the vents in end plates located
under the blower on either side of the
drain plug.
IMPORTANT
7614F Grain-Vac Operator's Manual 34-100853-6
Fig. 5-24 Blower Schematics.
Fig. 5-25 Breathers
52