Installing a Deskside DPE
2
A.
Plug one end of the copper cable into
the expansion (EXP) connector on
the DPE LCC.
B.
Tighten the two screws on the
cable's connector.
C.
Plug the other end of the copper
cable into the primary (PRI)
connector on the DAE LCC.
D.
Tighten the two screws on the
cable's connector.
EMC Disk-Array Processor Enclosure (DPE) Deskside Model FC4400/4500 Hardware Reference
2-12
10. Connect the LCC in the DAE to the LCC in the DPE using copper
cables as shown below.
Cabling a DPE to a DAE
Figure 2-10
DAE LCC
PRI
EXP
DPE LCC