Siemens CP 1612 A2 Operating Instructions Manual page 19

Qualified personnel
The device/system described here must only be set up and operated in conjunction
with this documentation. Only qualified personnel should be allowed to install and
work on this equipment/system. Qualified persons in the sense of the safety-related
notices in this documentation are defined as persons who are authorized to
commission, to ground, and to tag circuits, equipment, and systems in accordance
with established safety practices and standards.
Correct usage of Siemens products
Note the following:
WARNING
Siemens products may only be used for the applications indicated in the catalog
and in the relevant technical documentation. If third-party products and components
are used, these must be recommended or approved by Siemens. These products
can only function correctly and safely if they are transported, stored, set up,
mounted, installed, commissioned, operated and maintained correctly. The
permitted environmental and ambient conditions must be adhered to. Notices in the
relevant documentation must be observed.
Trademarks
All names shown with the trademark symbol ® are registered trademarks of Siemens
AG. Third parties using for their own purposes any other names in this document
which refer to trademarks might infringe upon the rights of the trademark owners.
Disclaimer of liability
We have checked the contents of this manual for agreement with the hardware and
software described. Since deviations cannot be precluded entirely, we cannot
guarantee full agreement. However, the data in this manual are reviewed regularly
and any necessary corrections included in subsequent editions.
CP 1612 A2
A5E01169863-01, Release 04/2009
Legal notices
19