Unpacking, Setting Up And Inserting The Battery - Silvercrest SHLF 2000 A1 Operating Instructions Manual

RP53439 HL mit FB LB7 Seite 6 Dienstag, 13. Juli 2010 4:00 16

4. Unpacking, setting up and inserting the battery

4.1 Setting up the appliance
Note! As the appliance and heating coils
are supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Please ensure meanwhile that there is
sufficient ventilation.
1. Unpack the appliance
packaging.
2. Remove the transport packaging.
Note: There is a piece of corrugated
cardboard positioned
appliance and the base 9 . This must also
be removed.
3. Check that the appliance shows no signs
of damage.
Warning! Ensure that there is suf-
ficient distance from the wall, fix-
tures and other appliances. The
distance must be at least 1.5 m to
exclude the risk of fire.
4. Select a location that complies with the
safety information (see "3. Safety infor-
mation" on page 3).
5. Select a location where the flow of hot
air is not directly aimed at people, ani-
mals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note: The appliance consumes up to
10 amperes of current. If you have plug-
ged other power consumers into the
same circuit, check that the maximum
load for the installed fuse is not excee-
ded, as otherwise the fuse will trip.
6
4.2 Inserting the battery
If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press
towards
middle and pull
out
from the compartment.
2. Remove the old
battery if present.
Note: Please observe the instructions for
between the disposal (see "8.2 Disposable/recharge-
able batteries" on page 10).
3. Insert a new battery.
Note: Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery com-
partment.
4. Slide the battery compartment back in
again.
the catch
the
the battery
–