Table of Contents
Advertisement
Available languages
Available languages
HOW
THE
HOOD WORKS
MODEL SDD2-L GLASS VERSION
A:
Light ON/OFF key
The light switches on and off only when the
carriage is fully OPEN.
Pressing this button with the carriage closed will
cause the carriage to open and then the light will
switch on.
The button also serves to switch off the light if it
is on.
B:
ON/OFF key
This starts the extraction carriage upward
movement and when it is fully open, it sets the
second extraction speed.
With the carriage open: it switches off the motor
and if on, the light; then it retracts the extraction
carriage.
C:
Key
This reduces the speed of the extractor motor
from the 4th speed until the motor switches
off, without closing the pull-out carriage.
D:
Indicators
This signals the speed setting, by only the
relevant LED switching on.
This signals that all filters have been
saturated by all LEDs switching on.
E:
Key
This increases the speed of the extractor motor,
from 1st to 4th speed, without moving the
extractor panel.
20
COOKER
F:
Timer
10 min after setting, it serves to stop the
extractor motor, close the carriage and switch
the lights off, if they are on. The set function is
signalled by the flashing LEDs "D" for the set
speed. The timer can be cancelled by pressing
the key again.
Other functions:
Automatic turn off:
After 4 hours of continuous working from the last
setup, the appliance turns off and closes
automatically.
Grease filters saturation:
After 30 hours of working, the speed indicators
"D" will all flash simultaneously, signaling the
grease filters saturation.
To reset this alarm, hold down the "TIMER"
button for at least 3 seconds, while the carriage
is open.
Calibration:
The cooker-hood carries out its self-calibration
every 3 complete cycles of its extractable unit.
"TIMER"
By
pushing
the
consecutively (MAX break between one push
and the other is 3 sec.) all the leds will flash and
the calibration will be reset.
After the next 3 cycles the downdraft will carry
out its self-calibration.
Stand-by:
When the extractable unit is closed and the light
is switched off, the control panel, after 6
seconds,
activates
reducing the brightness of the leds.
This function can be stopped by pressing
ON/OFF or LIGHT key.
key
6
times
the
Stand-by
function,
S-DD18
Advertisement
Chapters
Table of Contents
