Positioning The Switch; Items Required For Installation - NETGEAR M4500 Series Hardware Installation Manual

Ventilation
 The installation surroundings must have adequate ventilation. Proper clearance between
the switch and the wall or other equipment must be observed.
Rack Mounting
If installing on a rack, verify the following:
 Ensure the cabinet is stable and secure to withstand any unexpected movement, such as
an earthquake.
 Ensure the rack or cabinet can support the weight of the switch and other additional
weight.

Positioning the Switch

The switch is equipped with Power Supply Units (PSUs) and hot-swappable fan modules.
Before you install the switch, consider the airflow direction of the power supply and fan
modules. The air inlets are at the front of the switch. The air outlets are at the back of the
switch.
To ensure proper airflow, make sure that when you install the switch its air intake is
positioned in a cold aisle and the air exhaust is positioned in a hot aisle.
NOTE:
Verify that each module has the same airflow direction. Make sure the switch runs with all of
its power supply and fan tray modules taking in air from a cold aisle and exhausting air to
the hot aisle.
Rack Mounting the Switch
You can install the switch in most standard 19-inch (48.3-cm) racks.
CAUTION
Due to the switch's weight, it should be installed by at least two people.

Items Required for Installation

The following items are required to install the switch onto the rack:
 Phillips screwdriver
 Screws that fit the equipment rack
NETGEAR M4500 Series Switches Hardware Installation Guide 24
Hardware Installation