Table of Contents
Advertisement
Model M4500-32C
QSFP28 Port Connection
The switch is equipped with 32 QSFP28 ports. Each single port supports 40G or 100G by
using 40G or 100G cables or optical transceivers. The switch can support fan-out cable for
40G to 4 x 10G or 100G to 4 x 25G or 2 x 50G.
The QSFP28 ports are numbered and have corresponding QSFP28 port LEDs.
To install a QSFP28 module, do the following:
1
Slide the QSFP28 module into a QSFP28 port.
2
Push completely until the module locks into place.
3
Repeat the above procedures to install additional QSFP28 modules.
For more information about the QSFP28 port LED behavior when the network link is
established, refer to
NOTE:
Port 28 is not supported with fan-out function.
Fan tray of model M4500-32C
The switch chassis is equipped with six fan trays. Each fan module provides front-to-back
airflow and is hot-swappable. The NETGEAR model number for a fan module is AFT402.
NOTE:
To hot-swap the fan during operation, make sure to replace it within 30 seconds.
Power supply of model M4500-32C
Equipped with two power supply modules (PSUs), the switch can operate with either one or
two PSUs. If the switch uses two PSUs, you can hot-swap one of the PSUs during operation.
The airflow on the PSU from the front to the back.
21 NETGEAR M4500 Series Switches Hardware Installation Guide
"LED indicators of model
M4500-32C".
Advertisement
Table of Contents
