DXV Modulus Right Height D22020A Series Installation Instructions

1-piece elongated toilet concealed trapway

Advertisement

INSTALLATION INSTRUCTIONS
DXV Modulus
1-Piece Elongated Toilet
Concealed Trapway
Right Height
, Elongated Model D22020A Series
®
Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin.
(Certain installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH APPLICABLE LOCAL
PLUMBING AND BUILDING CODES
RECOMMENDED TOOLS AND MATERIALS
Most of the procedures require the use of common tools and materials, which are
available from hardware and plumbing supply stores. It is essential that the tools
and materials be on hand before work has begun.
Adjustable Wrench
Putty Knife
10'
Tape Measure
Regular Screwdriver
1

REMOVE OLD TOILET

a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
2

ROUGHING-IN DIMENSIONS:

NOTE: Distance from wall to
closet flange centerline must
be as listed below:
IMPORTANT: Water supply on the
wall is required at 3-1/2" (88 mm)
from centerline of the toilet and
5" (127 mm) from the finished floor.
(see rough-in). Water supply is
hidden behind the toilet. Water
supply line needs to be hidden
within toilet frame.
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2017
Sealant
Hacksaw
FINISHED
WALL
6-1/8"
(155 mm)
13/16"
(20 mm)
11-1/4"
(285 mm)
12"
(305 mm)
Masking Tape
Flashlight
2-2"x4"x20"
Level
28-1/4"
(717 mm)
C/L OF SEAT POST
HOLES
18-1/2"
(470 mm)
16-1/2"
(419 mm)
10-15/16"
FINISHED FLOOR
(277 mm)
- 1 -
PARTS NOT INCLUDED
20" Flexible
Supply Tube
PARTS INCLUDED
2-Closet Bolts
2-Wing Nuts
15-9/16"
(396 mm)
14"
(356 mm)
31"
(785 mm)
3-1/2"
3-1/2"
OR
(88 mm)
(88 mm)
10-1/2"
(267 mm)
7302254-100 Rev. A (9/17)
Wax Ring
WATER
SUPPLY
5"
(127 mm)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Modulus Right Height D22020A Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DXV Modulus Right Height D22020A Series

  • Page 1 , Elongated Model D22020A Series ® Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
  • Page 2 20” WATER SUPPLY LINE MASKING TAPE DRAIN CENTER LINE CLOSET BOLTS CLOSET FLANGE WAX RING Press firmly. INSTALL CLOSET BOLTS Place a strip of masking tape vertically Install closet bolts in flange channel up each side of the toilet bowl to TIP: Place two 2x4's on edge in and slide into place parallel to wall.
  • Page 3 Ecatepec, Estado de México 55540 Canada For residents of the United States, warranty Toll Free: 01-800-8391200 information may also be obtained by calling Toll Free: 1-800-387-0369 www.DXV.mx the following toll free number: (800) 227-2734 Local: 905-306-1093 www.DXV.com Fax: 1-800-395-1498 www.DXV.ca 7302254-100 Rev.

Table of Contents