Monte Carlo Fan Company 5SBR56 D-L Series Installation Instructions Manual page 5

31
Plug white wire from fan to white
wire from light kit. Then plug black
wire from fan to black wire from light
kit.
34
This step is for glass replacement
only. Remove 1 glass holder and place
glass in decorative body of light kit.
Replace glass holder to hold glass in
place.
37
HAND HELD INSTALL
Place face plate over battery compartment and
buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over 4
pins and snaping into place.
32
Lift light kit to the fan motor assembly. Align
the 3 screws with the key hole slot holes in the
light kit (see inset). Rotate the light kit as
shown. Then install the screw removed in the
previous step though the closed hole. Tighten
all 3 screws securely.
35
Twist light kit into place by turning
direction of arrow.
38
WALL MOUNT INSTALL
Install wall control unit to outlet box
using machine screws provided.
33
Install the 2x50 watt halogen bulbs. Do not
touch bulb surface as oily residue from skin can
cause the bulb to explode. Bulbs included.
WARNING: Over lamping the fan will
result in the fan lights shutting down
until the proper wattage of bulbs are
installed.Reset the lights by turning off
the wall switch, breaker,or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
36
Remove cover by snaping off from top or bot-
tom. Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready
A23 / GP 23A all 12V.Attach cover of remote
by placing over buttons and snap the battery
cover in place.
39
Attach front cover to wall control
with screws provided. Snap battery
cover in place.