Advertisement
•
DEVICE WALL MOUNT INSTRUCTIONS
You can mount the UBC1310BA10 on a wall using the 2 mounting
brackets on the side of the device. Two round or pan head screws
are recommended. See the figure below for measurements.
Label
Size in Millimeters (mm)
A
7.2 +/- 0.5
B
2.6 +/- 0.15
C
19.0 +/- 1.2
To mount the device on a wall:
1. Install the 2 screws horizontally on the wall 132 mm (5.19
inches) apart.
Note: The screws should protrude from the wall so you can fit
the device between the head of the screws and the wall. If
you install the screws in drywall, use hollow wall anchors to
ensure the unit does not pull away from the wall due to
prolonged strain from the cable and power connectors.
2. Mount the device on the wall
www.ubeeinteractive.com
UBC1310BA10 Quick Installation Guide
2
Advertisement
