Advertisement
-
Fold rear seat backrests forwards -arrows-.
Warning:
●
Observe that the side and pillar trims are not damaged.
●
Avoid contact to the side windows as antenna wires are
vapour-deposited and may be damaged.
-
Guide separating grid -1- at an angle through the tailgate opening.
-
Place a support on the side luggage compartment trim between the C-
pillar and the D-pillar.
-
Bring the opposite separating grid support in the position between the
C-pillar and the D-pillar.
-
Slide the separating grid forwards so that the front supports press
lightly against the trims of the C-pillars.
Note:
●
The fitting of the separating grid -1- is decribed for the left vehicle side.
The fitting of the separating grid for the right vehicle side is performed
in the same sense.
-
Slide the threaded studs of the left bracket -7- through the guide -A- on
the separating grid -1-.
-
Slide the left bracket on the support shackle -B- of the left backrest
lock.
-
Fit separating grid with star grip nut -5-.
-
Align separating grid.
-
Align plastic caps -2-, -3- and -4- to the trims.
-
Fold both seat backrests backwards again until the lock audibly
engages.
Note:
●
If the star grip nuts are tightened too tight both side and pillar trims
may be damaged.
-
Tighten right and left star grip nuts -5- until the sustainers of the
separating grid are laying on the trims without a play.
Notes:
●
Check all threaded joints after a brief drive and retighten, if necessary.
●
Check threaded joints regularly.
Warning:
●
It is not allowed to transport persons behind the separating grid!
●
The head restraints must always be adjusted to the respective head height
of the passengers.
●
Observe that the rear seat backrests are locked correctly.
●
Secure heavy load additionally with tensioning belts!
Distributed by Votex GmbH
Printed in Germany by Votex GmbH
2
1
1
5
A
7
B
3
5
4
2
Advertisement
