Table of Contents
Advertisement
so the wood does not bind, resulting in kickback.
3.
IMPORTANT: Do not loosen any screws for this adjustment until you have
checked with a framing square and made test cuts to be sure adjustments are
necessary.
4.
To parallel the Saw Blade (14-I) to the Miter Gauge Groove, lift the Blade Guard
(10D). Then, turn the Height Hand Wheel (4G) to raise the Saw Blade all the way
up. (See Figure D, page 13.)
5.
Draw a mark beside one of the Saw Blade (14-I) teeth at the front of the Saw
Blade. Place a framing square beside the Saw Blade on the mark. Make sure
the framing square is between the teeth and flat against the Saw Blade. Then,
measure the distance to the right Miter Gauge Groove.
(See Figure U, next page.)
6.
Turn the Saw Blade (14-I) so the marked tooth is at the back of the Saw Table
(17H). (See Figure U.)
7.
Move the framing square to the rear of the Saw Table (17H) and again measure
the distance to the right Miter Gauge Groove. If the distances are the same, the
Saw Blade (14-I) and the Miter Gauge Groove are parallel. (See Figure U.)
8.
If the distances measured are different, remove the Throat Plate (15H) from the
Saw Table (17H) in order to gain access to the Table Brackets (7-I) for adjustment
purposes. (See Figure U.)
9.
Lower the Saw Blade (14-I) completely with the Height Hand Wheel (4G). You
can then access the Table Brackets (7-I) through the Throat Plate opening.
(See Figure U.)
10.
From the back, loosen the three Hex Head Bolts (9-I) holding the Rear Table
Bracket (7-I) with a 12mm wrench (not included). (See Figure U.)
11.
If the Saw Blade (14-I) was too far from the Miter Gauge Groove, move the Rear
Table Bracket (7-I) toward the Miter Gauge Groove. Tap with a wood block and
hammer. (See Figure U.)
12.
If the Saw Blade (14-I) was too close to the Miter Gauge Groove, back the Rear
Table Bracket (7-I) with a block of wood and hammer. (See Figure U.)
13.
Tighten the three Hex Head Bolts (9-I). Raise the Saw Blade (14-I) and re-check.
(See Figure U.)
14.
Repeat the above Steps until the Saw Blade (14-I) is parallel to the Miter Gauge
SKU 93491
For technical questions, please call 1-800-444-3353.
Page 29
Advertisement
Table of Contents
