Changing The Tamper Foot Plate; Loading And Transport - Bomag BT 60/4 Operating And Maintenance Instructions Manual

4.9 Changing the tamper foot
plate
Fig. 28
After changing the tamper foot plate (Fig. 28)
l
tighten the 4 fastening screws with a tightening
torque of 60 ...70 Nm (44...52 ft.lbs).
i
Note
When changing the tamper foot to a different width
use only genuine BOMAG parts.
After changing the tamper foot check the engine
speed, adjust if necessary.
BT 60/4, BT 65/4

4.10 Loading and transport

Danger
!
Danger of accident!
Always shut the engine down to transport the
tamper to lay it on its side.
Make sure that persons are not endangered by
the machine tipping or sliding off.
Lash the machine down, so that it is secured
against rolling, sliding and turning over.
For lifting the machine attach the lifting gear
only to the cross strut on the engine protection
bow.
The machine should not swing about too much
when being lifted.
Do not stand under suspended loads.
Use only safe lifting gear of sufficient load
bearing capacity
Fig. 29
Always shut the engine down for transport.
l
Transport the tamper only lying down (Fig. 29)
l
on the castors.
BOMAG
Operation
27