Advertisement
Section 1.4: The CRT Terminal
The CRT Terminal with keyboard features an 80 column, 25 line display. Function keys allow you to execute
FACP commands from the keyboard.
Primary and Secondary Power
The CRT requires 120 VAC, 50/60Hz primary power. A secondary power source (battery backup) is not
provided; the use of a separate Uninterruptable Power Supply (UPS), UL listed for Fire Protective Signaling is
recommended.
Electrical Specification
Voltage:
Frequency:
Current
Installation
Connection between the AM2020/AFP1010 and the CRT is provided through an EIA-232 interface on the
Serial Interface Board (SIB). Assemble a custom cable for connection to the EIA port on the CRT. Connect
additional CRTs with installer-provided cables (AUX on first CRT to EIA port on second CRT, and so on).
Multiple Terminals
The AM2020/AFP1010 supports up to 25 terminals installed on the EIA-232 circuit of the Serial Interface
Board. Each CRT is shipped from the factory with a keyboard, used for programming the FACP. The keyboard
can only be used on the first CRT installed in the chain. Only the first CRT is supervised on the EIA-232 circuit.
When finished programming, remove the keyboard.
The AUX and EIA ports are located
on the back of the CRT-1 Monitor.
www.PDF-Zoo.com
CRT-1
CRT-2
120 VAC
90 – 264 VAC
60 Hz
47 – 63 Hz
0.6 A
0.5 – 0.2 A
AUX
EIA
Document 15094
PAR
SER2-AUX SER1-EIA
The PAR (Parallel), AUX and EIA ports are
located on the back of the CRT-2 Monitor.
Rev C
11/20/95
15094:C
Page 11
Hide quick links:
Advertisement
