Table of Contents
Advertisement
DC power supply installation
Job aid: Bezel models
Figure 8: Bezel models 312096-A and 321325-A
Removing the power filler panel
A power filler panel maintains the proper cooling airflow in the Ethernet Routing Switch
8800/8600 chassis. You must remove the power filler panel from the power bay when you
install a power supply in a bay for the first time.
Important:
To remove a power filler panel from the 8010co chassis with bezel model 312096-A installed,
you must remove the bottom front bezel (see
A
on page 38). For instructions, see
chassis
A, you need not remove the bezel.
Caution:
To maintain proper cooling, never operate the Ethernet Routing Switch 8800/8600 with an
empty power supply bay. If you are replacing a failed power supply and you do not have a
power filler panel, leave the failed power supply installed until a replacement power supply
is available.
Use the following procedure to remove the power filler panel.
38
Installation — DC Power Supply
on page 36. If you replaced bezel 312096-A with the modified bezel model 321325-
Comments? infodev@avaya.com
Figure 8: Bezel models 312096-A and 321325-
Removing the bottom bezel 312096-A of the 8010co
September 2012
Advertisement
Table of Contents
