Table of Contents
Advertisement
DC power supply installation
Figure 22: Tightening the retaining screws on the DC power supply: 8003-R chassis
Replacing the 8010co chassis bottom bezel model 312096-
A
Use the procedure in this section to replace the 8010co chassis bottom front bezel for model
312096-A.
Procedure steps
Important:
The 8005DC power supplies require a modified air intake bezel. If you have installed Model
8005DC power supplies (1500 W) in the 8010co chassis and have air intake bezel imprinted
with 312096-A, or if you have difficulty installing the bezel over the 8005DC power supplies,
you can order modified bezel model 321325-A (Order Code DS1411027).
1. Hook the two bezel slots on the two chassis tabs. See figure below.
2. Align the captive screws with the holes on the front of the chassis.
50
Installation — DC Power Supply
Comments? infodev@avaya.com
September 2012
Advertisement
Table of Contents
