Prerequisites
• If you install a power supply in the 8010co chassis with bezel model 312096-A installed, you
must remove the bottom front bezel.
For instructions, see
page 36.
Procedure steps
Important:
If you replaced bezel 312096-A with the modified bezel model 321325-A, you do not need
to remove the bezel.
1. Switch off the power supply. See the following figure for the exact location of the
Installation — DC Power Supply
Removing the bottom bezel 312096-A of the 8010co chassis
power switch for 8004, 8005, and 8005DI DC power supplies.
Installing the DC power supply
on
September 2012
41