Table of Contents
Advertisement
Procedure steps
1. Use a Phillips screwdriver to loosen the two captive screws that secure the power
2. Pull the power filler panel from the chassis.
Job aid: Power filler panel removal
Figure 9: Removing a power filler panel: 8010co chassis
Installation — DC Power Supply
filler panel to the chassis until the power filler panel disengages. See
filler panel removal
on page 39.
Caution:
Save the power filler panel in case you need to operate the Ethernet Routing
Switch 8800/8600 with a power supply removed.
Removing the power filler panel
Job aid: Power
September 2012
39
Advertisement
Table of Contents
