Accessories; Maintenance; Warranty - Weller WBTS 12L Operating Instructions Manual

English
To set the torque, screw ou unscrew the lock nut. Then the
removing steel ring can be fixed by a grain * taking care of
it in the appropriate grooves.
* grain not included in delivery
WTS D (Digital settings):
The control unit has the ability to set and display various
parameters (see manual WTS D).
The torque depends on the model tool used and the control
unit automatically recognizes the connected tool.
Depending on the model, the control unit will change
various parameters available on the menu.
To clarify all the possible settings, read the WTS D manual.
In models with clutch only some parameters can be chan-
ged and the torque should be adjusted manually as shown
in photos and as already described in WTS A description.
FRONT PANEL LIGHTS:
On the front panel you can also see 3 lights: the green one
(POWER) will light permanently when the power is on; the
yellow one (TORQUE) will light only when the torque has
been reached and the red one (ERROR) will light only when
the torque is not correct (screw closed or torque reached
during the RAMP time).
The temperature of the unit can normally reach 45°C.

5. Accessories

Order-No. Model
T005 87 677 01 WAH12
T005 87 677 02 WAH35
T005 87 677 03 WBAL
T005 87 677 04 WCAB5M
T005 87 677 05 WCAB5MS
T005 87 677 06 WTT5
Further accessories available on request.
6
ATTENTION:
On the back panel you can find a socket equipped with a
fuse holder and on/off switch. To replace the fuse just pull
out the fuse holder and change the fuse.
Always remember to switch off the control unit at the end
of each working shift.
To check the torque value we suggest the use of WTT5
torque tester.

6. Maintenance

The WTS control unit and the WBTS screwdrivers are
maintenance free
NOTE
The sound level generated by WELLER electric screwdrivers
is lower than 55dB(A). The vibrations transmitted to
operator's hand are lower than 2.5 m/s². In particular the
exposition to vibrations is lower than 1 m/s² for operators
who make up to 4200 screwing cycles per day.

7. Warranty

Claims based on defects will fall under the statute of
limitations 12 months after delivery to the purchaser of the
goods. This shall not apply to rights of recourse of the
purchaser according to sections 478, 479 German Civil
Code. We shall assume liability for warranties supplied by
us only if the quality guarantee or service warranty has
been submitted in writing and using the term "Warranty".
Subject to technical change without notice!
See the updated operating instructions at
www.weller-tools.com.
Features
90° Angle head for WBTS12L, Especially for tight work spaces
90° Angle head for WBTS12L, Especially for tight work spaces
Balancer, Working load limit from 0,4 to 1,0 kg
Connecting cable 5 m, Flexible connecting cable 8-pin
Connecting cable with twist 5 m, Flexible connecting cable with twist 8-pin
Torque tester until 5 Nm, Tester for screwdriver calibration