Powering The Qlabs; Off; Power Connection; Powering The Qlabs ® Electrometer Plus On - MICROPOINT qLabs ElectroMeter Plus User Manual

7. Powering the qLabs

Plus ON and OFF

7.1 Power Connection

The qLabs
be plugged into the qLabs
Alternatively, the qLabs
batteries (See Section 12.2).
7.2 Powering the qLabs
When qLabs
choices to power on the monitor:
1) Press the Power button, to view the prompt to insert a test strip, or
2) Insert a fresh test strip if you are ready to perform a test. The
qLabs
Code.
Turning the qLabs
to:
• Perform a test, or
qLabs.ElectroMeter.manual.Q-2 Plus.indd 10
ElectroMeter Plus comes with a power supply which must
®
ElectroMeter Plus power supply jack.
®
ElectroMeter Plus can use 4 standard AA
®
The messages on the four-cell grid displayed at the
bottom of the screen provide hints for the functions of the
buttons.
ElectroMeter Plus On
®
When the qLabs
powered on, it will beep and automatically
enter Setup mode. In the Setup mode you
can change the qLabs
settings, or
Press the "OK" button to view the prompt to
insert a test strip.
ElectroMeter Plus is in the standby mode, you have two
®
ElectroMeter Plus will then prompt you to confirm the Strip
®
ElectroMeter Plus ON in CHOICE 1, allows the user
®
ElectroMeter
®
ElectroMeter Plus is initially
®
ElectroMeter Plus
®
10
EN EN EN
2/12/2014 6:16:49 PM