Valor HORIZON H4 Series Installation Instructions Manual page 3

10. Replace main burner with propane gas burner
assembly supplied and reassemble module.
11. Lever off the small domed cap covering the
manifold pressure setting screw, on front face of
valve cover by using a screwdriver or similar.
Front Face of Control Valve
Pry off
Plastic Cap
12. Refi t the module (including front log brackets) and
log support to the appliance.
13. Fit the aeration shutter for propane gas set as per
diagram.
14. Turn on gas supply and check for leaks using soap
solution. The minimum and maximum gas supply
pressure are 11" and 14" w.c. and can be verifi ed
using the inlet supply pressure test tapping.
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1
15. Using a small straight blade screwdriver, back off
the plug screw within the manifold pressure test
tapping. Fit a manometer to the manifold pressure
test tapping.
16. Light the appliance and turn up to full fi re. Check for
leaks downstream of the valve. Adjust the manifold
pressure setting screw to 9.5" w.c. (534) or 10.5"
w.c. (650).
17. Turn appliance off. Remove the manometer and
tighten the test tapping screw. Refi t the domed
plug.
18. Fit the data conversion label and signed conversion
label close to the rating plate. Fit the control
conversion label near the controls.
19. Re-install all ceramics, check that the appliance
operates correctly. Refer to main instructions.
Designed and Manufactured by / for
Miles Industries Ltd.
Tel. 604-984-3496 Fax 604-984-0246
www.valorfi replaces.com
Manifold
Supply
pressure
pressure
test tapping
test tapping
Front Face of Control Valve
Pressure Adjustment Screw
behind Cap
Increases Pressure
Decreases Pressure
3