9.
If the cutting units stall or become erratic while
backlapping, select a higher reel speed setting
until the speed stabilizes, then return the reel
speed to setting 1 or to your desired speed.
10.
To make an adjustment to the cutting units while
backlapping, turn the cutting units off by moving
the Lower Mow/Raise lever rearward; the
Enable/Disable switch to the D
and shut off the engine. After completing the
adjustments, repeat steps
11.
Repeat the procedure for all the cutting units
that you want to backlap.
12.
When you are finished, return the backlap lever
to the M
position, lower the floor panel, and
OW
wash all lapping compound off of the cutting
units. Adjust the cutting unit reel-to-bedknife
contact as needed. Move the cutting unit reel
speed control to the desired mowing position.
Important:
If the backlap switch is not
returned to the F (M
backlapping, the cutting units will not raise
or function properly.
Note:
For a better cutting edge, run a file across
the front face of the bedknife after lapping. This
removes any burrs or rough edges that may
have built up on the cutting edge.
position,
ISABLE
5
through 9.
) position after
OW
Cleaning
Washing the Machine
Wash the machine as needed using water alone
or with a mild detergent. You may use a rag when
washing the machine.
Important:
Do not use brackish or reclaimed
water to clean the machine.
Important:
Do not use power-washing equipment
to wash the machine. Power-washing equipment
may damage the electrical system, loosen
important decals, or wash away necessary grease
at friction points. Avoid excessive use of water
near the control panel, engine, and battery.
Important:
Do not wash the machine with the
engine running. Washing the machine with the
engine running may result in internal engine
damage.
55