Draining The Water Separator; Changing The Fuel Filter Canister; Bleeding Air From The Injectors - Toro Reelmaster 3555 Operator's Manual

Draining the Water
Separator
Service Interval: Before each use or daily
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key from the ignition
switch.
2. Place a clean container under the fuel filter.
3. Loosen the drain valve on the bottom of the filter
canister (Figure 56).
Figure 56
1. Water separator/filter
canister
2. Vent plug
4. Tighten the valve after draining.
Changing the Fuel Filter
Canister
Service Interval: Every 400 hours
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key from the ignition
switch.
2. Clean the area where the filter canister mounts
(Figure 56).
3. Remove the filter canister and clean the
mounting surface.
4. Lubricate the gasket on the filter canister with
clean oil.
5. Install the filter canister by hand until the gasket
contacts the mounting surface; then rotate it an
additional 1/2 turn.
g009880
3. Drain valve
Bleeding Air from the
Injectors
Note:
Use this procedure only if the fuel system has
been purged of air through normal priming procedures
and the engine does not start; refer to
Fuel System (page
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, and
shut off the engine.
2. Loosen the pipe connection to the No. 1 nozzle
and holder assembly.
1. Fuel injectors
3. Move the throttle to the F
4. Turn the key in the key switch to the S
position and watch the fuel flow around the
connector. Turn the key to the O
when there is a continuous flow.
5. Tighten the pipe connector securely.
6. Repeat the procedure on the remaining nozzles.
44
Bleeding the
29).
Figure 57
position.
AST
position
FF
g008913
TART