Operating Tips - Toro Reelmaster 3555 Operator's Manual

back and forth, press the toggle button once.
This may be done as often as required. Do not
hold the button.
8. Sit on the seat and attempt to operate the
desired function of the machine. The appropriate
output LEDs should illuminate to indicate that
the ECM is turning on that function.
Note:
If the correct output LEDs do not
illuminate, verify that the required input switches
are in the necessary positions to allow that
function to occur. Verify correct switch function.
If the output LEDs are on as specified, but
the machine does not function properly, this
indicates a non-electrical problem. Repair as
necessary.
Note:
If each output switch is in the correct
position and functioning correctly, but the output
LEDs are not correctly illuminated, this indicates
an ECM problem. If this occurs, contact your
authorized Toro distributor for assistance.
Important:
The Diagnostic ACE display
must not be left connected to the machine. It
is not designed to withstand the environment
of the everyday use of the machine. When
you are finished using the Diagnostic ACE,
disconnect it from the machine and connect
the loop-back connector to the harness
connector. The machine does not operate
without the loop-back connector installed on
the harness. Store the Diagnostic ACE in a
dry, secure location in the shop, not on the
machine.

Operating Tips

Becoming Familiar with the
Machine
Before mowing grass, practice operating the machine
in an open area. Start and shut off the engine.
Operate in forward and reverse. Lower and raise
the cutting units and engage and disengage the
cutting units. When you feel familiar with the machine,
practice operating up and down slopes at different
speeds.
Understanding the Warning
System
If a warning light comes on during operation, stop the
machine immediately and correct the problem before
continuing operation. Serious damage could occur if
you operate the machine with a malfunction.
Mowing Grass
Start the engine and move the throttle to the F
position. Move the Enable/Disable switch to the
E position and use the Lower Mow/Raise lever
NABLE
to control the cutting units (the front cutting units
are timed to lower before the rear cutting units). To
move forward and cut grass, press the traction pedal
forward.
Driving the Machine in Transport
Mode
Move the Enable/Disable switch to the D
position and raise the cutting units to the transport
position. Move the Mow/Transport lever to the
T position. Be careful when driving between
RANSPORT
objects so that you do not accidentally damage the
machine or the cutting units. Use extra care when
operating the machine on slopes. Drive slowly and
avoid sharp turns on slopes to prevent rollovers.
32
AST
ISABLE