Adjusting The Turf Compensation Spring - Toro Reelmaster 3555 Operator's Manual

Figure 11
1. Lift-arm shaft lynch pin and washer
B. Insert the lift-arm yoke onto the carrier
frame shaft (Figure
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and lynch pin
(Figure 11).
12. Insert the cap over the carrier frame shaft and
lift-arm yoke.
13. Secure the cap and the carrier frame shaft to the
lift-arm yoke with the snapper pin.
Note:
Use the slot if a steering cutting unit is
desired or use the hole if the cutting unit is to be
locked in position
14. Secure the lift-arm chain to the chain bracket
with the snapper pin
Note:
Use the number of chain links specified
in the cutting unit Operator's Manual.
Figure 12
1. Lift-arm chain
2. Chain bracket
15. Coat the spline shaft of the reel motor with clean
grease.
16. Oil the reel-motor O-ring and install it onto the
motor flange.
17. Install the motor by rotating it clockwise so that
the motor flanges clear the locknuts
13). Rotate the motor counterclockwise until the
flanges encircle the nuts, then tighten the nuts.
10).
(Figure 9).
(Figure 12).
3. Snapper pin
(Figure
Important:
hoses are not twisted, kinked, or at risk of
being pinched.
g003979
1. Reel-drive motor
2
Adjusting the Turf
Compensation Spring
No Parts Required
Procedure
The turf compensation spring
weight from the front to the rear roller. This helps
to reduce a wave pattern in the turf, also known as
marcelling or bobbing.
Important:
Make spring adjustments with the
g003948
cutting unit mounted to the traction unit, pointing
straight ahead and lowered to the shop floor.
1. Make sure that the hairpin cotter is installed in
the rear hole in the spring rod
16
Make sure that the reel motor
Figure 13
2. Mounting nuts
(Figure 14) transfers
(Figure
g020322
14).