IBM Hardware Management Console Installing And Configuring page 53

Figure 20. Support arm connection
7. Install the L-shaped cable-management stop bracket (1) on the unattached end of the support arm.
Turn the bracket (2) to secure it to the support arm.
Figure 21. Cable-management stop bracket secured to the support arm
8. To attach the other side of the support arm to the backside of the slide rail, pull the pin out (1), and
then slide the bracket (2) into the slide rail.
Figure 22. Pin extended, bracket installed into slide rail
9. Pull out the mounting bracket pin (1) and slide the mounting bracket (2) into the slide rail onto
which you are installing the cable-management arm. Push the bracket into the slide rail until the
Installing and configuring the Hardware Management Console
39