Setting The Dip-Witches; Advanced Configuration Settings; Configuration Settings; Enable Mics Unmute At Startup - Yamaha XW-CS-700 Manual

Wireless extension microphone kit for the yamaha cs-700

Table of Contents

Setting the DIP-witches

Please ensure that the DIP switches on the back of the Receiver are set as bellow:

This setting ensures that the output of the Receiver provides mixed audio from microphone one and two in case more

than one microphone is being used (DIP 1), that no Low-pass filter is activated (DIP 2), that the Receiver provides mic-

level output (DIP 3), that the mute button on the microphone is not being used, audio will be sent in all cases (DIP 4), no

EQ will be applied (DIP 5 & 6), and the highest possible wireless signal strength shall be used (DIP7 & 8).

Advanced Configuration settings can be made using the Revolabs™ HD Control Panel Software. They are not required

for a successful operation of the wireless microphone but might be useful in specific meeting room settings. For a full

description of that software visit the Revolabs™ HD Single/Dual user documentation.

To use the HD Control Panel Software:

1. Download the Revolabs HD Control Panel software from

systems/hd-wireless-microphone-system/

2. Connect the PC to the HD Single/Dual Receiver via USB.

3. Allow the PC to recognize the hardware and install the necessary operating system drivers.

4. Install the software downloaded in Step 1, which requires Windows 7 or newer.

5. Launch the Revolabs HD Control Panel program.

The Revolabs HD Control Panel controls most of the HD Single/Dual Receiver configuration settings. It also provides real

time status of the microphones. Only one HD Single/Dual system can be controlled and monitored from a single PC at any

given time.

Some settings you might consider:

By default, the mics go into a muted state when they are removed from the Charger. This is done to prevent

handling noise as the microphone is placed into position. By selecting 'Mics Unmuted at Startup', the mics will go

into an unmuted state when removed from the Charger and become immediately active.

(2) Gain:

Each microphone has an individual gain fader. This fader provides +/- 10dB of gain in 0.5dB increments. The

microphone gains are stored in the Receiver and will be applied to any microphone paired to that channel. This

setting is useful to finetune the audio level of the wireless microphone.

https://uc.yamaha.com/products/microphone-

Table of Contents