You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button
(G) shortly (see figure 8).
•
Your device will automatically appear in the
Homematic IP app.
•
To confirm, please enter the last four digits of
the device number (SGTIN) in your app or scan
the QR code. Therefore, please see the sticker
supplied or attached to the device.
•
Please wait until teach-in is completed.
•
If connection of the device was successful, the LED
lights up green. The device is now ready for use.
•
If the LED lights up red, please try again.
•
Select the desired solution for your device.
•
In the app, give the device a name and allocate
it to a room.
If you are already using Homematic IP devices in
your smart home system or if you want to com-
bine your Homematic IP Wired devices with wire-
less Homematic IP components, you can also
connect the Homematic IP Wired devices to an
(installed) Access Point. Therefore, connect the
Homematic IP Wired Access Point to the (in-
stalled) Homematic IP Access Point, as described
in the user manual. Afterwards, please proceed as
described above to connect the motion detector.
Start-up
45