Instructions For Use; Oven Racks; Oven Extendable Racks (If Present) - BORETTI BPOP-60 Operating Instructions Manual

InSTRUCTIOnS FOR USe

Oven Racks

never use aluminum foil to cover the oven racks or to line
the oven. It can cause damage to the oven liner if heat is
trapped under the foil.
Make sure you do not force it to avoid damage to the enamel.
The oven has rack guides at four levels.
Rack positions are numbered from the
bottom rack guide (#1) to the top (#4).
Check cooking charts for best rack
positions to use when cooking.
Each level guide consists of paired
supports formed in the walls on each side of the oven
Always be sure to position the oven racks before turning on the oven. Make sure
that the racks are level once they are in position.
The racks are designed to stop when pulled forward to their limit.
To remove oven rack from the oven
(see Fig. 4):
1 Pull rack forward.
2 Lift rack up at front and then remove
it.
To replace an oven rack (see Fig. 5):
1 Place rear of rack between rack level
guides.
2 While lifting front of rack, slide rack in
all the way while lowering the front.
52
WARnInG
WARnInG
Fig. 3
cavity.
1
2
Fig. 4
1
2
Fig. 5

Oven extendable racks (if present)

The extendable rack allows for easier access to cooking foods. It extends beyond
the standard flat rack bringing he food closer to the user.
WARnInG
Make sute that:
• W hen the rack is outside of the oven, slide arms do
not lock. They could unexpectedly extend if the rack is
carried incorrectly. extending slide arms could cause
injury. Rack should only be held or carried by grasping
the sides.
• T o avoid burns, pull rack all the way out and lift pan
above handle when transferring food to and from oven.
Always remove the extendable rack before self-cleaning the oven.
To remove extendable rack from the
oven (see Fig. 6):
1 Lift of rack slightly and push it until the
stop release.
2 Raise back of rack until frame and stop
clear rack guide.
3 Pull rack down and out.
To replace an extendable rack (see Fig.
7):
1 Grasp rack firmly on both sides. Place
rack (including frame) above desired rack
guide.
2 Push all the way in until the back of the
rack drops into place.
3 Pull both sections forward until stops
activates. Rack should be straight and
flat, not crooked.
nOTe
1
2
3
Fig. 6
1
2
3
Fig. 7
NL
FR
EN
DE
53