Touchpad - HP EliteBook x360 830 G5 Maintenance And Service Manual

TouchPad

Table 6-4 TouchPad descriptions and part numbers
Description
TouchPad for use in models with NFC (includes TouchPad cable and NFC antenna)
TouchPad for use in models without NFC (includes TouchPad cable)
Before removing the TouchPad, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the TouchPad:
1. (NFC models only) Disconnect the NFC antenna cable from the ZIF connector on the NFC board (1).
The NFC antenna is spared with the TouchPad on models that offer NFC.
2. Disconnect the TouchPad cable from the ZIF connector on the card reader board (2).
3. Remove the six Phillips M1.6 × 2.5 screws (3) that secure the TouchPad to the computer.
TIP:
Removing these screws requires a Phillips P0 driver.
4. Remove the TouchPad from the computer (4).
Reverse this procedure to install the TouchPad.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 33).
42).
31).
Component replacement procedures
Spare part number
L56457-001
L56458-001
47