Warnings And Limitations - Honeywell Miller 8172 User Instruction Manual

All synthetic material must be protected from
sources. The use of heat resistant materials is
recommended in these applications.
Never use natural materials (manila, cotton,
etc.) as part of a fall protection system.
Environmental hazards should be considered
when selecting fall protection equipment.
Equipment must not be exposed to chemicals
which may produce a harmful effect. Polyester
should be used in certain chemical or acidic
environments. Use in highly corrosive or
caustic environments dictates a more frequent
inspection and servicing program to ensure the
integrity of the device is maintained. Contact
Miller Technical Services if in doubt.

1.1 Warnings and Limitations

ROPE GRABS/WIRE ROPE GRABS
Do not attempt to service the device or alter it in any way.
Attach the device to appropriate vertical lifelines only.
grain material, or particulate solids such as sand or coal.
VERTICAL LIFELINES
requires a minimum tensile strength of 5,000 lbs. (22.2kN).]
Never allow the lifeline to become slack or to pass under or entwine around arms, legs,
neck, or any other obstacle.
user to prevent a swing fall.
SYSTEM
A competent person must ensure the compatibility of all connections and that of the
system.
the system does not operate properly.
The device and lifeline should be installed and used in such a manner as to reduce the
potential for a swing fall.
Us er In stru ctio ns - Engli sh
4
Do not allow equipment to come in contact
with anything that will damage it including, but
not limited to, sharp, abrasive, rough or high-
temperature surfaces, welding, heat sources,
electrical hazards, or moving machinery.
Always check for obstructions below the work
area to make sure potential fall path is clear.
Allow adequate fall clearance below the work
surface.
Never remove product labels, which include
important warnings and information for the
authorized person/user.