Magnum MIG 208 Alu Synergy Manual page 6

SAFETY INSTRUCTION
electric welding
3.1. General thoughts.
a) The work must begin rested, sober, dressed in clothing made of slow-burning fabric or leather,
her hair covered with a beret or cap, on the legs have shoes with trousers hardly inflammatory
hands welding gloves and personal protection apron leather, welding mask, goggles, personal
respiratory protective equipment.
b) Work related to installation, dismantling, repair and overhaul of electric welding equipment should
be performed by workers with the appropriate permissions.
c) the combination of several welding power sources should not cause exceedance, no-load condition, the
allowable voltage between the output circuits connected sources of energy.
d) circuit of the welding current should not be grounded, except for the cases when the objects welded are
connected to ground.
e) Welding the connecting wires welded to the subject power source to be connected directly to the e) Welding the connecting wires welded to the subject power source to be connected directly to the
subject or instrumentation, as close as possible to the welding point.
3.2. Basic steps before you begin work.
Welder should:
a) refer to the documentation of the executive and the scope of the welding work,
b) schedule the execution order of individual welds,
c) prepare a suitable adhesive,
d) prepare adequate protection face and eyes,
e) check the condition of the welding connections and the operating handle,
f)
check whether the execution of the welding does not endanger the environment (radiation curve, the possibility of
ignition elements flammable)
g) check whether in the case of welding on the wall, the other side can not occur inflammation,
3.3. During welding operations.
a) Secure the workplace, as long as there is no fixed and mobile screens with anti
przeciwodpryskowymi.
b) Use for welding electric conductors and an operating handle only in good condition (intact
insulation).
c) Use only the correct thickness of the electrodes and wires for welding.
d) Attach and set reliably and solidly welded object and so has not been damaged.
e) Set the details to be welded in such a way as to prevent them from shifting or overturn.
When you flip slag needle use hammers and goggles.
f) When welding inside the boilers, tanks or in a confined space by whatever ventilation use f) When welding inside the boilers, tanks or in a confined space by whatever ventilation use
respiratory protection.
g) When operating inside the tanks, boilers and other metal rooms used electric lighting 24V.
h) Make sure that the welded part does not risk falling or moving away the dangerous to the welder.
6