Connection Of Sensors To M12 Plugs For T63 And T73; Electrical Installation, Control Terminals - Danfoss VLT FCD 300 Series Design Manual

3 Installation

3.5.14 Connection of Sensors to M12 Plugs for T63 and T73

3
For rating specifications see
Terminals 203/204 are used for sensor supply.
Terminal 203 = common
Terminal 204 = +24 V
Terminals 201/202 can be used for a separate 24 V supply.

3.5.15 Electrical Installation, Control Terminals

See section entitled Earthing of screened/armoured control cables
No.
01-03
12
18-33
20, 55
31a, 31b
35
36
42
46
50
53
60
67
68, 69
70
D
V
P
N
G
VLT 2800/FCM 300/FCD 300 Profibus DP V1 Operating Instructions
* See
FCD 300 AS-interface Operating Instructions
90.BX.YY) or
52
General technical data
, digital inputs terminals 18, 19, 29, 33.
Function
Relay outputs 01-03 can be used for indicating status and alarms/warnings.
24 V DC voltage supply.
Digital inputs.
Common frame for input and output terminals. Can be separated with switch S100
Motor thermistor
Common (-) for external 24 V control back up supply. Optional.
External + 24 V control back up supply. Optional.
Analog output for displaying frequency, reference, current or torque.
Digital output for displaying status,warnings or alarms, as well as frequency output.
+10 V DC supply voltage for potentiometer
Analogue voltage input 0 - +/- 10 V DC.
Analogue current input 0/4 - 20 mA.
+ 5 V DC supply voltage to Profibus.
Fieldbus serial communication*
Ground for terminals 67, 68 and 69.
Normally this terminal is not to be used.
For future use
+5V, red
RS485(+), LCP2/PC, yellow
RS485(-), LCP2/PC, green
OV, blue
(MG.04.EX.YY).
MG.90.S1.02 - VLT
in the Design Guide for the correct termination of control cables.
VLT 2800/FCD 300 DeviceNet Operating Instructions
(MG.90.AX.YY),
®
is a registered Danfoss trademark
®
VLT Decentral FCD 300 Design Guide
(MG.