Introduction; Safety Instructions - Fichtelbahn ReadyHUB Manual

R
eady
Line
FichtelBahn

01. Introduction

This manual explains the basics step by step for using this module. Careful reading and
taking note of tips will reduce potential errors and therefore the amount of work to
solve failures.
Designated Use
The normal use of the ReadyHUB is for model making especially digital model railways
according to this manual. Every improper use leads to loss of warranty.
Package Contents
- ReadyHUB module with casing
- Connection terminal for supplying power
- 2x jumper (2,54 mm/1 in grid) for bus termination
- Manual
Required Materials
- Switching power supply with 12V-18V DC (min. 1A current)
- RJ45 patch cable for connection to BidiBus

02. Safety Instructions

To reduce the risk of electric shock and injuries do not touch parts that carry voltage.
Do not touch conductive material that might carry voltage in case of a fault, e.g. short
circuit, improper input voltage, excessive humidity and accumulation of condensate.
To reduce these risks, keep these safety precautions in mind:
Use this module only indoors and in a clean and dry environment. Avoid moisture and
splash water in close proximity.
Switch off the voltage supply before carrying out wiring work. Only use wire with
sufficient cross-section. Wait for 2 hours after accumulation of condensate.
Manual ReadyHUB Page 19
© 2019 FichtelBahn
Manual Version 1.0
Technical changes and errors reserved