Advertisement
Lift machine off the pallet to the
desired location.
Use lifting straps and place them as
shown in Fig 1.
Fig 1
Warning:
The machine weight is 145 kg.
Assure the sufficient load capacity
and proper condition of your lifting
devices.
Never step underneath suspended
loads.
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Place the machine stable on wooden
blocking.
Wheel mount
Slide the axles (A, Fig 2) through the
swivel base and place one wheel (B)
on each side before you secure with
the supplied split pins (C).
Fig 2
Material stop mount
Insert the stop rod (A, Fig 3) into the
bed and tighten the screw (B).
Slide stock stop (C) onto the rod and
tighten the thumb screw (D).
Fig 3
Pulley cover mount
Slide the belt cover over the pulley
assemblies and fasten with screws
and washers (A, Fig 4).
Close belt cover and secure with lock
knob (B, Fig 4)
Fig 4
Coolant Tank Preparation
Use of a water-soluble coolant will
increase cutting efficiency and prolong
blade life.
Follow manufacturers instructions as
to its uses and precautions.
Fill the tank to approximately 80% of
capacity.
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked
H07RN-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Starting operation
You can start the machine with the
green on button (A, Fig 5). The red
button (B) on the switch box stops the
machine.
The coolant pump (C) can be
switched on and off independently.
The switch cover (D) has an
emergency stop function and can be
used to lock the machine.
Fig 5
Note:
The saw is equipped with an
automatic Shut-Off.
The saw should stop just after the cut
has been completed. The stop tip has
to be adjusted accordingly.
6. Machine operation
Support long workpieces with helping
roller stands.
Advertisement
