Changing Wiper Blades - Honda ODYSSEY 2020 Owner's Manual

MAINTENANCE
If the specified brake fluid is not available, you should use only DOT 3 or DOT 4
fluid from a sealed container as a temporary replacement.
Using any non-Honda brake fluid can cause corrosion and decrease the
longevity of the system. Have the brake system flushed and refilled with Honda
Heavy Duty Brake Fluid DOT 3 as soon as possible.
If the brake fluid level is at or below the MIN mark, have a dealer inspect the
vehicle for leaks or worn brake pads as soon as possible.

Changing Wiper Blades

If the wiper blade rubber has deteriorated, it will leave streaks and the hard
surfaces of the blade may scratch the window glass.
1. Set the power mode to VEHICLE OFF.
2. While holding the wiper switch in the
MIST position, press the POWER button
three times. Both wiper arms are now
set to the maintenance position.
3. Lift both wiper arms.
194 |
4. Press up on and hold the tab, then slide
the holder off the wiper arm.
5. Pull the end of the wiper blade in the
direction of the arrow in the image until
it unfastens from the holder's end cap.
6. Pull the wiper blade to the opposite
direction to slide it out from its holder.
7. Insert the flat side of the new wiper
blade onto the bottom part of the holder.
Insert the blade all the way.
8. Install the end of the wiper blade into
the cap.
9. Slide the wiper holder onto the wiper
arm until it locks.
10. Lower both wiper arms.
11. Set the power mode to ON and hold the
wiper switch in the MIST position until
both wiper arms return to the standard
position.
Avoid dropping the wiper arm onto the windshield, it may damage the wiper arm
and/or the windshield.
MAINTENANCE
| 195